GageWay KW QuickStart Guide

Let's start by communicating with the GageWay KW

Plug the GageWay KW into a USB port on your computer.
The red LED on the GageWay KW will flash several times and then the LED will go out after a few seconds.
Plug a gage into the GageWay KW.
If using a hand switch or foot switch, plug it into the jack located on the side of the GageWay KW.
Open Excel, Word, Notepad or your target application to verify you can get a reading from the connected gage.
Take a reading with the connected gage.
- Use the read button on the gage to take a reading.
- Press the foot switch or hand switch to take a reading.
You should see the reading come into the application you’re using for testing. Be sure to give the test application the focus by clicking on it.
Your GageWay KW is ready for years of work!

GageWay KW is a hardware keyboard wedge that allows you to transfer gage measurements into …